26" - 27.5" - 29" Front/Rear Rigid Mountain Bike Mudguard Kit V3 - Black

Front: Blade length: 553 mm Blade width: 73 to 97 mm Total weight: 120 g Rear: Blade length: 497 mm Blade width: 73 to 95 mm Total weight: 230 g

The front mudguard comes with 2 expanders allowing it to be mounted on steerer tubes with a diameter between 19.2 and 24.2 mm, & 29 and 35 mm. The rear mudguard comes fully assembled and ready to be mounted, no matter the diameter of your seat post.

With dimensions that fit all the new wheel and tyre sizes on the market, and with a bold design, our mudguard kit gives your bike a modern, sporty look. Everything has been designed to give you the best experience: - A reliable screw-on bracket that holds the mudguards in the same position each time - An easy system to clip the blades onto and take them off your bike depending on the weather - Compatibility with accessories (camera, lights)

This wide, shock-resistant mudguard kit stops mud getting sprayed onto the rider\'s lower back, chest and face. To do this, place the rear mudguard as close as possible (2 to 3 cm) to the wheel. You can\'t completely avoid muddy splatters when it\'s damp... But for getting from A to B, we recommend using a hybrid bike mudguard kit (with longer blades that are closer to the wheels), if compatible with your bike frame and tyre width.

In dry weather, when there\'s no rain and mud about, you can unclip the blade from the rear bracket and clip a sports camera on instead. \'GoPro’ clip system. For your safety on trips early in the morning or late at night.A rail is provided at the end of the rear mudguard blade to accommodate a CL 100, CL 500, CL 900, ST 500 or RL 510 type red rear light.

This kit is suitable for 26\" to 29\" mountain bikes, with a tyre width up to 2.8\" in 27.5\" and 2.6\" in 29\", equipped with a telescopic fork. To ensure a good fit at the front, the internal diameter of the steerer tube must be between 18 and 34 mm.In the case of fork steerers ranging from 23 to 24 mm, do not hesitate to use the smallest mounting parts and tighten them firmly. To ensure a good fit at the rear, the diameter of the seat post must be between 25.4 and 34.9 mm.