Men’s Waterproof Hiking Shoes - NH500 Mid WP

The sole’s design is the result of long research carried out in our labs. It is composed of a specific rubber formula which optimises grip and traction. We are systematically looking for the best compromise for walking on soft (e.g. forest paths) and stony (e.g. coastal paths) hiking trails.When used on roads, this can lead to the premature wear of your boots and cause discomfort. They are not suitable for mountain walking.

Laboratory tests were conducted to test the following elements: tearing eyelets and straps, gluing, toxicology, UV resistance, abrasion resistance of outsole and upper components, accelerated ageing. These tests allow us to improve the quality of our products and prevent premature wear of our hiking shoes.

The NH500 WP shoes have been laboratory tested for 8000 flexes. They are therefore waterproof for 8 hours hiking. During the waterproofing test, we test 3 levels of waterproofing: - 2,000 flexes, approximately 2 hours of hiking- 4,000 flexes, approximately 4 hours of hiking- 8,000 flexes, approximately 8 hours of hikingWe recommend you use a waterproof spray several times a year to restore the original water-repellent properties and reduces stains.

Laboratory- and field- tested, these shoes have a membrane to ensure optimal waterproofing and breathability. First, the shoe is immersed in water while internal air pressure is applied to check that no bubbles form on the surface of the footwear. Next, shoes are fitted to a mechanical arm that simulates walking and half immersed in water so we can test that the inside remains perfectly dry.

Try on both shoes, standing up, with the socks worn for hiking. Try on several models or sizes if necessary. Check two comfort points:- the heel seating- the front of the foot on a downward slopeAvoid any pressure points when fitting. Feel free to walk around to test the comfort and support. Gradually start using you shoes during your first few hiking trips to break them in.

These shoes are slightly breathable, but not enough to evacuate all humidity created by your perspiration. We advise you to choose Hike 100 Mid socks: they contain moisture-absorbing cotton and have a reverse terry-knit construction under the sock that wicks moisture away from your foot. They are also high enough to protect your ankle from the shoe. It is an excellent combination to reduce the chance of blisters.

After your hikes, we advise you to:- Leave your shoes to dry near a heat source- Brusquely brush, using a hard-bristled brush, the dry leather to remove any mud and dirt- Use a soft-bristled brush or nubuck eraser to remove any stains- If the stains are stubborn, clean them using a brush and a little warm water- Leave to dry- Brush again using a hard-bristled brush- Spray with a waterproofing product: this will make the leather shine and bring out the colours